Double-sided tape for splicing
Support of non-woven fabric covered on both sides with a modified acrylic adhesive. It comes with liner paper pumpkin color.
For all types of joints, with good behavior and high temperature in the range between -20 and 180 °C. Suitable for porous material, impregnated foams, cellular PE and rubber, laminated light PVC and laminated felt.
We offer all widths and lengths.
Click here to view the technical data
General introduction:
- is an assembling system consisting of a thin carrier (paper, non woven, film or others), coated on both sides with a uniform layer of adhesive.
- The adhesives used are pressure-sensitive acrylic polymer or synthetic rubber based formulations.
- Is produced in roll or sheet format with a single or double release liner, so that the product chosen best suits the customer’s needs.
Product description:
- Consists of a non woven carrier coated on both sides with a modified acrylic adhesive.
- Is produced in self wound format on a White PE coated paper liner.
Typical application:
- Good resistance to temperature, appropriate for open pore material, impregnated foam, cellular PE, cellular rubber, soft PVC and felt fabric lamination.
CHARACTERISTICS:
Adhesion with Substrates |
Metal / Aluminium |
High |
Textile / Cotton |
High |
Glass / Ceramics |
High |
Rubber / EPDM |
High |
Painted Surface |
High |
Acrylic / PET |
High |
Wood / Board / Paper |
High |
Polystyrene |
High |
Soft PVC |
Medium |
PP / PE / PS |
High |
Rigid PVC |
High |
Smooth substrate |
High |
PC / ABS |
High |
Rouge substrate |
High |
Resistance:
- Low resistance to water, plasticizers and alcohol, and low outdoor resistance. Not recommended for use in contact with aliphatic or aromatic hydrocarbons. For further technical advice, please consult with ATYT.
Shelf life:
- 2 years when stored at 15/25º C and 50% relative humidity.
Adhesive Data |
|
Typical values |
Test Method |
Quick Tack (N/25mm) on stainless steel |
21 |
FTM 9 |
Peel 180º- (N/25mm) on
stainless steel
- after 20 minutes
- after 24 hours
|
23 25 |
>FTM 1 FTM 1 |
Shear on stainless steel 1Kg-25mm x 25mm (hours) |
> 150 |
FTM 8 |
Temperature Resistance |
Minimum application temperature |
-5ºC |
|
End-use temperature range |
-10º C to + 80º C |
|
Short term resistance |
+ 115º C |
S.A.F.T. 500grs |
For temperatures outside those quoted above, please consult with ATYT
Release liner |
Silicone white PE coated paper of 120gr/sqm |
ISO 536 |
Thickness (carrier + adhesive) |
90my |
ISO 534 |